background image

WARRANTY 

 

All fiber optic transmission systems, products and accessories 
manufactured by Liteway, Inc. and it’s subsidiaries are fully tested 
prior to shipment and are warranted against defective materials 
and workmanship for a period of two full years from the date of the 
original shipment.  Should a problem occur, a Return Material 
Authorization Number (RMA) must be obtained from Liteway Inc. 
at (516) 931-2800 and the item returned to Liteway, Inc. 166 
Haverford Road, Hicksville, NY 11801, USA, prepaid.  Liteway Inc. 
will then, at its option repair or replace the defective item.   
 
Liteway, Inc. maximum liability under this warranty is limited to the 
cost of the defective item only.  No contingent liabilities of any kind 
are either assumed or implied. 
 
Any items returned to Liteway, Inc. that have been misused, 
abused, damaged, modified, connected or adjusted in any way 
contrary to the instructions furnished by Liteway, Inc. or repaired 
by unauthorized personnel will not be covered by this warranty.  
Any non-warranty repairs required will be quoted at the current 
rate for such services. 

 

 
 

Important Notices 

 
 

CAUTION !

   

AVOID DIRECT EXPOSURE TO BEAM

All -7,-8, and -9 Models use laser diodes. These solid-state laser 
diodes are located in the optical ports of these units.  Laser diodes 
produce invisible radiation that may be harmful to human eyes.   
Never look directly into the optical port of any fiber optic unit 
designed to operate with single-mode optical fiber. 
 
 

NOT FOR LIFE SUPPORT SYSTEMS 

Liteway, Inc. does not authorize or warrant any of its products or 
accessories for use in critical life support systems or applications 
of any kind. 

 
 
 
 
© Copyright 2007 Liteway, Inc   

 

 

 

 

 113378 Rev A 

OPERATING INSTRUCTIONS 

 

 

 

Fiber Optic  
 
Video Multiplexer 
 
Model VT-8004, VR-8004

 

 
 
 
 
 
 

 
 
The VT/VR-8004 system consists of the VT-8004 transmitter and VR-
8004 receiver and will transmit four separate channels of high quality 
base-band video on one fiber in accordance with NTSC, PAL and 
SECAM specifications. 
 

Technical Specifications 

Video Bandwidth 

7 MHz 

In / Output Impedance 

75 ohms 

In/Out Signal Level 

1 volt peak to peak 

Signal/Noise Ratio 

60 dB minimum 

Differential Gain 

3% maximum 

Differential Phase 

3º maximum 

Operating Wavelength 

1300 (-3,-7), 1550 (-9) 

Optical Output 

-14 dBm typical 

Optical Loss Budget 

 0 – 13 dB 

Fibers Accommodated 

1 Multimode (-3), 1 Single-mode (-7,-9)  

Temperature Range 

-35º to +75ºC 

Power Requirements 

11-18 VAC/DC @750 mA 

Physical Size (mm) 

 5.2”()L x 1.1.” ()W x 12.5”()D 

All specifications measured with 1Km of 62.5u multimode fiber. 
All specifications are subject to change without prior notice. 

 

 

!

Reviews: