2
SAFETY WARNING AND INSTRUCTIONS
When using electrical equipment, basic safety precautions should always be observed.
Read and follow all safety instructions.
• Risk of fire or electric shock. Luminaire wiring and electrical parts may be damaged when drilling for
installation of LED Emergency Backup. Check for enclosed wiring and components.
• Risk of fire or electric shock. This LED Emergency Backup installation requires knowledge of luminaire
and electrical systems. If not qualified, do not attempt to install. Contact a qualified electrician.
• Before installation, make certain the AC power to the fixture is off.
• The electrical rating of this product is 100-347V Vac. Installer must confirm that there is 100-347V Vac to the
fixture before installation.
• To prevent electrical shock, only mate unit connector after installation is complete and before the AC power
to the fixture is back on.
• Do not use outdoors.
• This LED Emergency Backup unit requires an un-switched AC power source of 100-347V Vac, 50/60Hz.
• Do not let power supply cords touch hot surfaces.
• Do not mount near gas or electric heaters.
• Equipment should be mounted in locations and at heights where it is not subjected to tampering by
unauthorized personnel. The use of accessory equipment is not recommended by the manufacturer and
may cause an unsafe condition.
• Do not use this equipment for other than its intended use - only use for LED Lighting emergency backup.
• Use with grounded, UL/ETL listed, dry or damp location rated fixtures.
• CAUTION: The EB40 provides more than one power supply output source. To reduce the risk of electrical shock,
disconnect both normal and emergency source by turning off the A.C. branch circuit.
• CAUTION: Servicing of this equipment should be performed by qualified personnel only.
• CAUTION: Do not attempt to service the battery. A sealed, no-maitenence battery is used that is not field
replaceable. Replace the entire unit when necessary.
• CAUTION: The use of accessory equipment not recommended by the manufacturer may cause an unsafe
condition, void warranty, and result in non-compliance with UL specifications.
• For use in 32°F minimum, to 122°F maximum ambient temperatures. Suitable for use in damp locations
and plenum spaces.
• Not for use in heated air outlets or hazardous locations.
COMPATIBILITY
The EB40 is compatible with all LED fixtures less than 300W. All fixtures must also include 0-10V
dimming if wattage is greater than 40W.
PLEASE NOTE:
Although tested and compliant with UL924, when used with a sensor-equipped
fixture, unless the sensor wiring is accessible and bypassed, the sensor settings will remain active,
overriding the EB40 emergency power to the fixture, and cause the fixture to dim or turn off based on
its occupancy programming. This may not be ideal during emergency egress and may not meet code
requirements. We recommend that if the EB40 is used on a sensor-equipped fixture, the sensor be
programmed to maintain full light output when occupancy sensing or daylight harvesting is active.
