Autolume Series Area Light
Installation Instructions
LITELUME™ seeks to deliver the most advanced and efficient LED technology. Due to
technology progression, specifications may change. We reserve the right to update product
specifications without notice. Contact LITELUME™ for the most up-to-date data.
www.litelume.com
[email protected]
833.LED.LUME
Page 2/4
Rev Date: 08/20/2018
©Lite Lume Corporation 2018
3A. If the U-bracket is fastened to UBMP through its screw hole #1 & 4, the U-bracket or the light body can be rotated as per
Figure 3. Fasten M8 screws at 20 N.M. torque after the needed tilting angle is adjusted to correct position
Lumen output from
the optic side
Installation Platform
2B. To rotate the U-bracket towards the heatsink/junction box side of the LED luminaire (the rotation range is 0° to 90°), place
two pieces of check washers onto screw hole 2 & 3 (see Figure 4) of UBMP, fasten the U-bracket and the round plate through the
middle screw hole of UBMP using 1 piece of Hex head screw (M8) properly, then fasten the U-bracket using another two pieces of
screws (M8) through screw hole 2 & 3 properly (not too tight to rotate the U-bracket / light body).
Screw hole 2
Screw hole 3
90°
U-bracket
mounting piece
PROCEED to 3B
3B. If the U-bracket is fastened to UBMP through its screw hole #2 & 3, the U-bracket or the light body can be rotated as per
Figure 5. Fasten M8 screws at 20 N.M. torque after the needed tilting angle is adjusted to correct position.
Lumen output from
the optic side
Installation Platform
