18.) Insert loose actuator
cord wires into compartment
below actuator plate.
19.) Position actuator cord
cover
located
in
the
cardboard box over actuator
cable and bolts securing
actuator plate to base. Cover
is secured using magnets.
20.) Expect a slight gap
between actuator and cover
OR base and cover when
installed properly.
21.) Locate battery and
position in base. NOTE: 300
S &D models DO NOT have
removable battery continue
to step 24.
22.) Turn control box on by
rotating the red button
clockwise.
The
battery
capacity
display
should
display four solid black bars
indicating a full charge. If the
display does not show any
solid black bars check battery
connection.
NOTE:
Battery
requires
charging of once per week
overnight regardless of use.
23.) LiteGait® is powered by
a rechargeable battery. To
charge, remove battery from
base and connect charger to
battery.
FlexAble
17.) If applicable, pivot the
yoke arm over the top of
the LiteGait® Post as shown
in the following images. The
yoke should be resting on
the FlexAble Cartridge
16.) Insert bolts and hand
tighten. Make sure while one
person is inserting bolts, the
other is holding the actuator.
Tighten the bolts until snug
using the Allen wrench.
CAUTION: DO NOT over
tighten the bolts.
Post
