INSTALLATION
•
There are specific regulations like DGUV V17/18 (old BGV C1) or country related regulations which need to
attend during the installation. The installation has to be handled by skilled persons only!
•
Suspension device hast to be built and calculated in order to handle up to 10 times its specific load limit over
a time of one hour without permanent or harmful deformation.
•
Installation has to be done with a separate, independent suspension device like a safety chain. A second
suspension device has to be built in order to assure that in case of error no part of an installation can fall off.
•
Trepassing the danger zone below the installation during the assembling is prohibited.
•
Installer has to take care of all safety and machinery installations are approved by authorized persons before
first operation or after changes before restarting.
•
Installer has to take care of all safety and machinery installations are approved by skilled persons at least
once a year.
•
Installer has to take care of all safety and machinery installations are approved by authorized persons at least
every four years during the acceptance inspection.
•
Spotlight should ideally installed outside peoples lounge area.
ATTENTION!
Installation overhead needs a high level of experience. This includes (but is not just limited to) calculation and
definition of load capacity, used installation material and regular safety inspections of used material and the fixture
itself. Never try to do the installation by yourself if you are not qualified, instead you have to instruct a skilled installer.
Inappropriate installations can cause injuries and/or damage of property.
•
Spotlight has to be installed outside areas where people can touch it.
•
Professional truss system or similar licensed suspension systems have to be used if the spotlight is used in
suspension from ceiling or other constructions. Spotlights can never be installed freely suspended!
ATTENTION!
Spotlights can cause injuries when fall off. If you are not trained in questions of safety for the different kinds of
installation do NOT install the spotlight!
•
Assure that the mounting surface can hold at least ten times the point load of the spotlight before installing the
fixture.
ATTENTION!
Assure the specified safety distances to flammable material.
•
Attach the spotlight with its yoke and the use of a suitable hook/clamp to your truss system. According to your
installation also similar but approved suspension devices are possible. The therefor used thread has a size of
M10.
•
When installing the spotlight overhead make sure to safe the fixture by a safety chain which is specified at least
with a load limit of 12 times of the spotlights weight. Only safety chain with approved connective can be used.
Attach the safety chain to its designated opening and attach it to the truss system or a similar and safe
attachment point. Assure to close the fasteners as specified.
•
To adjust the angle of the fixture open the locking screw, set the fixure in its position and close it by hand.