OPERATION:
•
This device has several DMX, manual and audio modes. In DMX mode,
multiple devices can be connected and controlled by a controller. The device
accepts the settings of the DMX-controller, as soon as the corresponding start
address is set.
•
Slave mode:
Connect the DMX output of the master device (XLR female) to the DMX input
of the slave device (XLR male). Set the slave device to mode 5 with the start
address 001 (display shows: 5001). Turn the unit off and on again. The slave
device accepts all settings of the master device (such as color macro mode,
dimmer program mode, dimmer program speed, dimmer red, dimmer green,
dimmer, dimmer blue, dimmer white, color changes synchronized to audio).
•
Display description:
The display shows the DMX start address and the different DMX modes. The
first digit shows the mode, the last three digits show the DMX start address (1-
512), one of the pre-programmed modes or the speed values (1-16). If a DMX
mode is choosen, but actually there is no DMX signal present, the display
flashes.
•
Button description:
Press the MODE button repeatedly to select the mode. Press the UP or
DOWN button to set the DMX start address or any of the pre-programmed
modes or the speed values. Use the UP button to increase the value. Use the
DOWN button to decrease it.
NOTE!
If you hold the UP or DOWN button for longer than 3 seconds, the value
changes faster. The device has an automatic storage for all settings. When
you turn the device off and on again, it works with the previously set values.
•
Pot
Description:
The knob controls the sensitivity of the audio control in the audio mode.