Connect Series Hardware Shelf Mounting Instructions
AudioConnect
TM
Manual
15
Connect Series Hardware Shelf Mounting Instructions
Four
, 4
-40
x
1
/4
"
Ph
illip
s Flat
Head
Scr
ews per
devi
ce
4 mounting holes per unit
Front panel of device faces
rack ears of shelf
Rack Ear
The Connect Series of instruments
from Listen, Inc. can be rack mounted
using the Hardware Shelf Kit, p/n 4901.
Four devices can be mounted on the
shelf as shown.
Each Connect Series device is
attached to the shelf with four,
4-40 x 1/4” Phillips flat head machine
screws (included).
Mounting
Remove the rubber feet from the
bottom plate of the Connect Series
device to expose the 4-40 threaded
inserts.
Next place the device on the rack shelf
with the front panel of the device facing
the “rack ears” of the shelf.
Insert 4 Phillips screws through the
bottom of plate into the device and
hand tighten.
Use only the 1/4” long screws
provided. Using longer screws can
damage the pc board of the device.
Summary of Contents for AudioConnect Series
