L R - 4 2 0 0 - I R I D S P R E C E I V E R M A N U A L
l
PAGE 14
Auto Power Mode
The auto power mode will automatically power the receiver on when the unit is removed from
the charging device, displaying the unit ID, battery status and the active channel. When the unit is
returned to the charging device the unit will automatically turn off and resume charging operation.
Your Listen receiver has been shipped to you with the Auto Power Mode enabled.
Auto OFF Mode
The Auto OFF Mode when enabled will automatically turn the receiver off after a period of time if no
IR signal is detected by the receiver. There are four setting OFF, 10, 15, and 30 minutes. Your Listen
receiver has been shipped to you with the Auto OFF Mode enable to 30 minutes.
Unit ID
The unit ID number provides a unique identification for each receiver that is displayed on the OLED
status screen. This can be any 3 digit number between 000 and 999. The unit ID allows venues to track
individual units and for easy dispensing and inventory control. Your Listen receiver has been shipped to
you with a Unit ID of 000.
Brightness Control
The Brightness Control adjusts the level of brightness of the OLED display. There are four settings Auto,
Bright, Dim and Disabled. In the Auto mode the unit uses an internal light sensor and automatically dims
the display when the light level is below approximately 10 Lux. In the Bright, Dim or Disabled mode the
unit disables the light sensor and leaves the OLED in the selected Bright or Dim state. In the disabled
mode the unit disables the display from lighting during normal operation except for the power on
sequence or when the power button is momentarily pressed to check status. The receiver is shipped
with the Auto Brightness Control Mode enabled.
Auto Seek Mode
When Auto Seek Mode is enabled the receiver will power up to the same channel that it was on
when it was last turned off. If no signal is present or the signal is lost on that channel the receiver will
continuously seek for a channel with IR signal until one is found. Auto seek is excellent for applications
where users are moving from room to room or exhibit to exhibit. Auto Seek Mode has two settings ON
and OFF. Your Listen receiver has been shipped to you in the Auto Seek OFF Mode.
Jack Sense
The jack sense mode when enabled will automatically turn the receiver on when a headset is inserted
into the 3.5 mm output jack on the receiver. The receiver will automatically turn off after 60 seconds
when the headset is removed from the 3.5 mm output jack. Your listen receiver has been shipped to
you with the Jack Sense Mode disabled.
Note: If Jack Sense is on and Auto Power is on, the receiver will ignore jack sense while on the charger.
