LISTENRF SETUP
Setting up Transmitter
Connect Antenna
If using the LT-803, remove the
rubber plug on the top of the unit
and connect the antenna.
If using the LT-800, connect the
antenna to the back of the unit.
Connect Power
Plug the power supply into the
power connector on the back
panel, then into an outlet. Turn on
by pressing the power button.
Connect Audio
There are two audio inputs; input
1 is a balanced connection using
either an XLR or 1/4” phono
connector. Input 2 has two
unbalanced mixing RCA
connectors.
Connect Dante Audio Adapter
with Audio (optional)
If you are using the Dante Audio
Adapter, connect the RJ45 network
cable into the Dante Adapter &
plug one of the XLR outputs to
input 1 on the LT-800/803 & the
other XLR output into the MX-5 AE
server.
Audio Source
RF Transmitter
Power Input
Antenna Output (LT-803)
Antenna Output (LT-800)
RJ45 Network Cable
Dante Audio Adapter
Network
Audio Source
MX-5 AE Server
RF Transmitter
Setting up Receivers
Micro-USB
Charging
Port
Power
Adjust Volume
Power
To turn on the iDSP receiver, hold the
button for one second.
Plug in Headset
Adjust Volume
To desired level.
The receiver is charged with a micro
USB charging cable provided with the
system. When connected to the
charger, a blinking light indicates it is
being charged and a solid light
indicates a full charge.
Power
Open the front access door, use
“battery” select switch to assign
battery type, install batteries. Rotate
the volume dial counterclockwise to
power on.
Plug in Headset
Adjust Volume
To desired level.
Front
access
door
Power & Volume Control
LR-4200
LR-200
For further customization, view the QSGs (quick start guides) and manuals found at
www.listentech.com/support/manuals
1.
2.
3.
1.
2.
3.
1.
2.
3.
OR
LISTEN TECHNOLOGIES
14912 Heritage Crest Way, Bluffdale, Utah 84065-4818 USA
Phone:
+1.801.233.8992
Toll-Free:
1.800.330.0891
www.listentech.com
Copyright © 1998 - 2018 Listen Technologies Corporation. All rights reserved. 09142018-V1
