LISEO Air tight L51, Installation And Use Manual

Page: 14 / 18

INSTALLATION AND USE MANUAL
4.
INSTALLATION AND ASSEMBLY
IMPORTANT
The chimney can only be installed and connected to the flue by a specialized
technician, respecting in every time the national and local standards and in
compliance with UNI 10683.
4.1.
PREPARATION AND UNPACKING
When you unpack the fireplace, check for perfect operation, as well as the possible
presence of shipping damage. Any anomalies must be immediately reported to the
transport carrier or seller.
Check the accordance with what is provided.
The chimney must always move in VERTICAL position.
The glass is fragile, it's necessary to protect it.
If possible, unpack the fireplace near the area where you will install it.
4.2.
GENERAL ASSEMBLY RULES
The appliance must always lean on a structure which support the weight and leave at least
5 cm air gap between the chimney and walls
If the chimney is placed on a floor or near combustible walls, a proper insulation is
recommended.
4.5.
ASSEMBLY OF CLADDING
The fireplace and the parts of the cladding must be attached together WITHOUT ANY CONTACT
WITH STEEL STRUCTURE to prevent heat transmission to the coating and allow thermal expansions.
Beware of wood finishes such as beams or shelves, which must be properly insulated.
In particular, the shelves should be placed at a distance upper to 30 cm from the top of the appliance.