Liquip Sales GPI EZ-8, Owner'S Manual, Page: 5 / 12

921803-01 Rev F 5
Step 5
If the power cord provided is too long, using a util-
ity knife, cut to desired length. Using utility knife,
carefully strip 3 to 4 inches (7.5 to 10 cm) of outer
insulation from end of power cord.
DO NOT CUT
INNER WIRES . Next, strip ¼ inch (0.6 cm) of insu-
lation from the black and red power cord wires.
Step 6
For a negative ground system, first disconnect the
vehicle’s ground wire, and then wire as follows:
Insert one end of the fuse (J) into the wire con-
nector (H) and crimp. Insert the red power cord
wire into the other end of the wire connector and
crimp. Make sure the fuse is positioned outside
of hazardous areas and as close to the battery
as possible. Make a solid electrical connection to
the grounded side of the battery with the remain-
ing black wire. Connecting directly to the battery
terminal or the end of the battery cable is recom-
mended.
Step 7
For temporary wiring: Connect the red and black
power cords to alligator clamps (not included)
(Figure 6).
Figure 6
Step 8
For permanent wiring:
Connect the red and black power cords to termi-
nal post rings (not included) (Figure 7).
Figure 7
Step 9
Check all connections to make sure they are con-
nected per instructions and all electrical codes.
The installation is now complete.
Step 4
Place the nozzle into the nozzle holder on the end
of the pump motor housing. Note that the nozzle
cannot be placed in the holder unless the pump
switch is OFF (Figure 5).
Figure 5
CONNECT TO A POWER SOURCE
Please consult the Owner’s Manual for your vehicle
before proceeding.
NOTE: The pump is designed for use with a 12-
volt power source. Do not attempt installation
on a 24-volt or 115-volt system.
WARNING: Do not attempt to power the pump
from vehicle wiring smaller than 14 gauge,
such as the cigarette lighter wire, as these thin
wires could overheat and cause a fire.
NOTE: This pump is pre-wired for installation in
CLASS I, DIVISION 2 locations such as portable
fuel tanks, trailers, etc. Connection to a battery
will depend upon the application.
WARNING: If pump is to be installed in
a CLASS I, DIVISION I location please
contact GPI for the appropriate product.
Verify switch is in OFF position, then route the
electrical wires to the source of the vehicle power
system. Be sure to support the wires as neces-
sary and protect them from sharp edges, heat or
anything that could damage the wires.