Technical Manual "Thunderbird/MM” Version 1.2
12.08.2005
Page 17 of 48
2 Hardware Installation
The Thunderbird/MM is delivered with the correct jumper settings for proper operation. The
customer must not change the default jumper settings. Improper jumper settings will cause system
instability or system hang-ups.
Attention:
The board must not be connected or disconnected to
peripherals (e.g. HDD, FDD, etc.) with the power supply
switched ON!
2.1 Adapter Cable Set
With the optionally available cable set, standard PC peripherals can be easily connected to the
board. The adapter cable set comprises the following items:
•
One adapter cable IDC10 female to DB9 male for serial port 2
•
IDC44 / 2.0mm ATA100 or ATA133 cable to connect i.e. 2.5’’ EIDE hard disks
•
Flat foil cable 26p. plus PCB adapter to 34p. female 2 row 2.54 mm grid
(standard FDD connector)
The flat foil cable must be inserted in the FFC connector with the blank side on the top. Be careful
not to damage the small safety lever at the floppy connector.
©
LIPPERT
Automationstechnik GmbH • Hans-Thoma-Str. 11 • 68163 Mannheim • Tel: 0621/43214-0 • Fax: 0621/43214-30
