5
lci1.com
574-537-8900
Rev: 03.19.18
Solera
®
Universal Hardware
Manual Awning to
Solera Hybrid Awning
(For Aftermarket Applications)
CCD-0001269
A B
Fig.6
12.
Place the Solera end cap
(Fig.6B)
on the end of the roll
tube
(Fig.6A)
, making sure it is properly seated and the roll
tube channel is aligned with the channel on the end cap.
13.
Secure the Solera end cap to the roll tube with the
provided rivets.
NOTE:
It may be necessary to drill out the previous holes
in order to accommodate the larger-sized rivets.
14.
Insert the Solera drive head assembly shaft
(Fig.7B)
into the end cap
(Fig.7A)
.
NOTE:
When identifying the drive head assembly from the
idler head assembly, the drive head assembly will have the
eye bolt for the crank
(Fig.7C)
and manual override plug
(Fig.7D)
. The idler head assembly will not.
Fig.7
15.
Align the holes in the shaft and end cap and secure
with the provided #8 - 32 x
1/2
” wax screw
(Fig.8)
.
NOTE:
Keep the head of the wax screw
1/8
” from fastened
to avoid compromising the structural integrity of the wax screw.
Fig.8
16.
Place the drive support arm assembly directly under
the awning rail so the top of the mount arm is touching the
bottom of the rail.
17.
Slide the drive support arm assembly outward to align
below the holes of the awning that was removed before
securing the upper bracket.
NOTE:
Silicone sealant
MUST
be used on all screws and
holes to prevent water from infiltrating the unit.
B
A
C