4
574-537-8900
Rev: 02.06.20
Solera
®
Awning LED
Light Strip Kit
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0002359
Fig.4
Installation
LED Light Strip
NOTE:
Awning
MUST
be extended to access the polycord
on the awning fabric and to run the LED power wire down
the drive mount arm.
1.
Starting on the drive side of the awning, slide the LED
light strip (non-wired end)
(Fig.3A)
onto the polycord of
the awning fabric
(Fig.3B)
, located close to the awning rail
(Fig.3C)
down the width of the awning fabric to the end,
towards the idler side.
2.
Flip the LED light strip drive side (wired end) up to see the
back side of the light strip.
3.
Install a #10 - 16 x
3/8
” pan head screw
(Fig.4A)
into the
black plastic track of the LED light strip. Make sure to install
the screw at a slight angle in between the LED light strip and
the polycord in the awning fabric, to prevent the LED light
strip from sliding off the awning fabric polycord.
Fig.3
A
B
C
Removing the Old LED Light Strip
NOTE:
Awning
MUST
be extended to access the polycord
on the awning fabric and the LED power wires down the
drive mount arm.
1.
If replacing only the LED light strip, remove the old LED
light strip by locating and removing the #10 - 16 x
3/8
” pan
head screw
(Fig.2A)
located on the drive side, in the back of
the LED light strip, holding the LED light strip in place.
Fig.2
A
2.
Cut the wires to the old LED light strip just inside the
wall of the unit. The wires to the new LED light strip can be
spliced into the old wires rather than replacing all the wiring
to the switch and power source and replacing the switch.
3.
Remove the old LED light strip by sliding the LED light
strip completely out from the awning fabric polycord.
NOTE:
If the light switch needs to be replaced as well,
remove the two #8 x 1” pan head screws in the light switch
plate
(Fig.5B)
. Remove the light switch, plate and disconnect
the wiring to the LED light strip and the power source.