Lippert Components Siphon 360, Installation Manual, Page: 2 / 4

Rev: 07.11.18
Page 2
CCD-0001584
TABLE OF CONTENTS
Introduction 2
Preparation 2
Resources Required
2
Installation Requirements 2
Installation 3
Introduction
The 360 Siphon® RV holding tank vent cap removes odors from the source. Odors are exhausted through
the roof vent before they have a chance to invade the RV living space. By design, the 360 Siphon® can
only create an updraft, expelling odors and fostering an oxygen-rich environment to speed up waste
breakdown. The 360 Siphon® acts immediately after installation in any wind condition (with or without a
breeze) to provide an environment for proper decomposition. It replaces factory-installed vent caps and is a
permanent maintenance-free application.
Preparation
Resources Required
• Cordless or Electric Drill or Screw Gun
• Appropriate Drive Bits
• 4 Fasteners
• Butyl Tape
• Sealant
Installation Requirements
1.
Water that might enter the Siphon port must drip into the stack. The purpose of the funnel (Fig. 2) is to
channel excess water into the stack.
2.
The 360 Siphon® must be sealed to the roof.