4
574-537-8900
Rev: 08.14.20
Schwintek
Motorized TV Lift
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0002647
5.
Mount the TV assembly to the rack
(Fig.3C)
using
customer supplied hardware into the pre-drilled holes in
the rack.
NOTE:
The amount of hardware used and the placement
of screws in the pre-drilled holes in the TV plate and rack
will vary depending on the model of TV. Flip the TV plate
(Fig.3A)
horizontal or vertical to accommodate installation
to the TV. Make sure the TV is secure to the TV plate and
the TV assembly is secure to the rack. The top of the TV
(Fig.3B)
should not exceed the top of the rack
(Fig.3C)
.
3.
Mount TV lift controller
(Fig.2)
close to end of motor wire
harness
(Fig.1C)
using two #10 screws in the pre-drilled
locations
(Fig.2B)
.
Fig.2
A.
Plug motor control wires
(Fig.1C)
into TV lift
controller
(Fig.2A)
.
B.
Attach the power, ground and switch wires with ¼”
spade type connectors
(Fig.2C)
. See the Wiring Diagram
section for proper wiring.
NOTE:
The wire harness-to-battery and switch are
customer-supplied items. Harness wires must be 10
AWG minimum. Also, 30 amp circuit protection should be
installed on the power lead wire between the battery and
the controller. See the Wiring Diagram section.
4.
Mount included TV plate
(Fig.3A)
to the back of the TV
(Fig.3B)
using customer-supplied hardware.
A
B
B
C
Fig.3
A
B
C
