Rev: 12.02.20
Page 5
CCD-0003430
Hitching to Tow Vehicle
1.
Chock the tires of the trailer.
2.
Press EXT (Fig. 2B) if needed to allow the coupler to clear the hitch ball.
3.
Position the tow vehicle under the trailer's hitch.
4.
Push RET (Fig. 2A) to retract the Power Stance tongue jack until the coupler properly mounts the hitch
ball and the leg of the Power Stance tongue jack is fully retracted.
5.
Reconnect all electrical and mechanical connections between the trailer and tow vehicle.
6.
Make sure the leg of the Power Stance tongue jack is fully retracted and tire chocks are removed prior
to moving the tow vehicle.
Power Swap Auxiliary Cord - Optional
The Power Swap Auxiliary Cord (Fig. 4) allows the user to power the Power Stance tongue jack from the
battery of the tow vehicle when there is no battery power from the trailer.
NOTE:
The Power Swap Auxiliary Cord is optional and sold separately.
All electrical wiring harnesses shall be loomed and secured to prevent possible damage and
installed in accordance with RVIA electrical standards.
Fig. 4
A
B
1.
Insert the 7-way plug (Fig. 4A) into the 7-way connector on the tow vehicle.
2.
Insert the 2-pin connector (Fig. 4B) into the plug receptacle of the Power Stance tongue jack (Fig. 2C).
