10
574-537-8900
Rev: 11.18.19
Innolight Sliding
Electric Step
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0002550
Fig.10
Maintenance
1.
Make sure unit is parked on a stable, level surface.
2.
Make sure power to the unit is turned off and/or
disconnected.
PRIOR TO STARTING MAINTENANCE PROCEDURES,
DISCONNECT POWER TO THE STEP’S ELECTRICAL
SYSTEM TO PREVENT INADVERTENT USE OF THE
STEP.
3.
After driving on roads that are salted, wash the step with
fresh water.
NOTE:
If protective panels need to be removed for service
or maintenance, reinstall panels as soon as possible after
service/maintenance has been completed.
Troubleshooting
Emergency Operation
The sliding electric single step is equipped with a manual
activation option.
1.
Locate the hole under the step.
2.
Using a screwdriver or a special tool (PN 8560867-0-
ZF00), insert it into the hole
(Fig.10)
3.
Push up the driving gear to disengage the electric motor.
4.
Move the step to the desired position.
5.
Remove the tool in order to stop the steps from moving.
