Rev: 07.30.18
Page 4
CCD-0001522
Wiring Landing Gear
Note: Circuit protection is not supplied. LCI recommends two 20 amp auto-reset circuit breakers be used
for the landing gear motors in addition to a 30 amp auto-reset circuit breaker placed in line with the
power source.
Note: See Wiring Diagram to complete these steps. OEM will need to supply miscellaneous wiring and
wiring connectors.
Note: A minimum of 6 AWG wire is needed on all power and ground wiring.
Note: The Wiring Diagram illustrates a curbside view.
1. Mount the two 20 amp circuit breakers above the landing gear motors.
2. Mount the 30 amp circuit breaker to be in line with the power source.
3. Mount the landing gear switch on the curbside front area of the trailer under the bulkhead.
4. On the curbside landing gear motor, connect the red wire from the wiring harness pigtail to the silver
post (AUX) of the 20 amp circuit breaker.
5. On the roadside landing gear motor, connect the red wire from the wiring harness pigtail to the silver
post (AUX) of the 20 amp circuit breaker.
6. Extend the black ground wire from the harness pigtail of the roadside motor to the black ground
wire coming from the harness pigtail of the curbside motor. Connect both wires to the switch's black
ground wire.
7. Connect the switch's red wire to the bronze post (BAT) on the curbside 20 amp circuit breaker.
8. Connect red wire from the bronze post (BAT) of the curbside 20 amp circuit breaker to the bronze post
(BAT) of the roadside 20 amp circuit breaker.
9. Connect the switch's pink wire to the silver post (AUX) of the 30 amp circuit breaker.
10. Connect the black wire from the switch to the negative terminal of the battery.
11. Connect the positive terminal of the battery to the bronze post (BAT) of the 30 amp circuit breaker.
12. Plug both curbside and roadside pigtail harnesses into their respective jack harnesses.
