24
TrainMaster Command operations
Reprogramming the Command reverse unit to restore features
D
ue to the inevitable derailments and static, it is possible that your Command reverse unit
could someday lose its setup program. The symptom of this condition would be
unresponsiveness in Command mode. This can be easily remedied by “reprogramming” your
Command reverse unit using the following steps.
STEP 1:
Move the switch on your locomotive from RUN to PROG.
STEP 2:
Plug in your Command Base.
STEP 3:
Place the locomotive on track, then turn on power to your track.
STEP 4:
Press
ENG
then input the locomotive’s ID#. Press
SET
.
STEP 5:
Press
ENG
, the ID#,
AUX1
, then press
74
for this particular locomotive.
STEP 6:
Turn off power to your track and wait ten seconds.
STEP 7:
Remove the locomotive from your track, and move the switch from PROG to RUN.
STEP 8:
Place the locomotive back on track, then turn power on to the track.
STEP 9:
Press
ENG
and the ID#, then operate as normal.
