B
efore you assemble this accessory, attach the wires from your power supply to the two
spring clip terminals on the base. Refer to Figure 2 for the location of the terminals.
Power this accessory with your transformer, Lionel LockOn, or separate accessory power supply.
1. To make the proper connections, the ends of the wires must be stripped
back 1/4” to 3/8”. Use a pair of wire strippers or a sharp knife to strip
the wires.
Only an adult should perform this task! Always use care when stripping wires.
2. Connect one wire to the Common/Ground/U terminal of your power supply
and attach it to one of the spring clip terminals at the bottom of the
Lighted Station.
To attach this wire, simply depress the spring clip and insert the bare end of the wire
into the exposed opening. Release the clip, and gently tug on the wire to be sure
that you have a good connection.
3. Connect the other wire to the A terminal of your power supply and attach
it to the other spring clip terminal.
Wiring your Lighted Freight Station
4
Connection
Clip
To
12-18
Volts
Bottom of Station
Figure 2. Wiring the Lighted Freight Station
Caution!
Note!
POWER
SUPPL
Y
COMMON/GROUND/U
POWER/A
OR
