21
Maintaining and servicing your set
Troubleshooting
No lights or operation
Be sure that the CW-80 Transformer is plugged in and the wires are connected.
Train runs, but WHISTLE, BELL, and DIRECTION buttons do not work
Check track connections. The track must be connected to the “A” and “U” terminals on the
Transformer.
No change when DIRECTION button is pressed
Be sure that your locomotive’s reverse unit switch is ON. Press the direction button for a duration of
one to four seconds.
Locomotive runs slowly or lights dim at the far end of the track
On larger layouts, additional track resistance may cause reduced track voltage as the trains move
away from the power terminal section. Install additional FasTrack terminal sections around your
layout and connect them to your Transformer to distribute power. Note that locomotives may decrease
speed slightly around curves.
Green light begins to flash
Be sure that all the wheels are properly on the track. Ensure that no metal objects are in contact with
the track to cause a short. Also, be sure that the power limit of the Transformer has not been exceeded;
the unit will gradually reduce power until the problem is corrected. Note that the light will also flash
when you hold down all three buttons to set the accessory voltage.
Bell button blows whistle
Switch the wire connections at the Transformer terminals. The U terminal should be connected to the
outside (common) rail.
Locomotive smoke is light or absent
Be sure that the Smoke Unit switch is in the ON position. Add four to six drops of smoke fluid if you
have not done so already.
We invite you to visit www.lionel.com and click on the Customer Services tab
to order parts and access other important service information.
Summary of Contents for 2-8-4 Berkshire Passenger
Page 23: ...23 Notes...
