OTX-***-HH-LR8-HS BUTTON ASSIGNMENTS
This diagram illustrates the relationship between the button locations and
encoder data lines.
ASSEMBLY DIAGRAM
Page 7
Page 6
Page 7
INSTRUCTION TO THE USER
This device complies with Part 15 of the FCC Rules.
Operation of this device is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment has been certified to comply with the limits for a Class B
computing device, pursuant to FCC Rules. In order to maintain compliance with
FCC regulations, shielded cables must be used with this equipment. Operation
with non-approved equipment or unshielded cables is likely to result in
interference to radio and TV reception. The user is cautioned that changes and
modifications made to the equipment without the approval of manufacturer
could void the user’s authority to operate this equipment.
Place the above statement in the instruction manual or insert card.
COMPLIANCE REQUIREMENTS
The OTX-***-HH-LR8-HS has been pre-certified by Linx Technologies for FCC
Part 15 and Industry Canada RSP-100 compliance. The 433.92MHz version has
also been tested for CE compliance for use in the European Union. The 315MHz
and 418MHz versions are not legal for use in Europe.
LABELING / INSTRUCTION REQUIREMENTS
The OTX-***-HH-LR8-HS Long-Range Handheld Transmitter has already been
labeled in accordance with FCC, Industry Canada, and CE regulations in effect
as of the date of this document. No further labeling of the unit is needed;
however, it is necessary to include the following statement in the end product’s
instruction manual or insert card for FCC compliance. Industry Canada only
requires the shaded portion. The EU does not require a statement.
Page 6
FCC ID: OJM-OTX-XXX-LRMSA
FCC ID: OJM-OTX-XXX-LRMSA
IC: 5840A-LRMSXXXA
IC: 5840A-LRMSXXXA
418MHz
418MHz
Figure 5: OTX-***-HH-LR8-HS Assembly
D6
D7
D4
D5
D2
D3
D0
D1
Figure 4: OTX-***-HH-LR8-HS Button Assignments
