–
–
–
–
32
33
Usage Guidelines for FCC Compliance
The TT Series module is provided with an FCC and Industry Canada
Modular Certification. This certification shows that the module meets the
requirements of FCC Part 15 and Industry Canada license-exempt RSS
standards for an intentional radiator. The integrator does not need to
conduct any further intentional radiator testing under these rules provided
that the following guidelines are met:
•
An approved antenna must be directly coupled to the module’s U.FL
connector through an approved coaxial extension cable.
•
Alternate antennas can be used, but may require the integrator to
perform certification testing.
•
The module must not be modified in any way. Coupling of external
circuitry must not bypass the provided connectors.
•
End product must be externally labeled with “Contains FCC ID:
OJMTRM900TTA / IC: 5840A-TRM900TTA”.
•
The end product’s user’s manual must contain an FCC statement
equivalent to that listed on page 33 of this data guide.
•
The antenna used for this transceiver must not be co-located or
operating in conjunction with any other antenna or transmitter.
•
The integrator must not provide any information to the end-user on
how to install or remove the module from the end-product.
Any changes or modifications not expressly approved by Linx Technologies
could void the user’s authority to operate the equipment.
Additional Testing Requirements
The modules have been tested for compliance as an intentional radiator,
but the integrator is required to perform unintentional radiator testing
on the final product per FCC sections 15.107 and 15.109 and Industry
Canada license-exempt RSS standards. Additional product-specific testing
might be required. Please contact the FCC or Industry Canada regarding
regulatory requirements for the application. Ultimately is it the integrator’s
responsibility to show that their product complies with the regulations
applicable to their product.
Note:
The integrator is required to perform unintentional radiator testing
on the final product per FCC sections 15.107 and 15.109 and IC
RSS-GEN.
Information to the user
The following information must be included in the product’s user manual.
FCC / IC NOTICES
This product contains FCC ID: OJMTRM900TTA / IC: 5840A-TRM900TTA
This device complies with Part 15 of the FCC rules and Industry Canada
license-exempt RSS standards. Operation of this device is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Any modifications could void the user’s authority to operate the equipment.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes:
1. l’appareil ne doit pas produire de brouillage, et
2. ’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
