Network Phone Camera User Manual
3 Basic operation
3.1 Turn on
Plug the power supply and turn on the power supply switch to “ON”, the Skypecam enters the
system.
Suggest using the stable input voltage and power input ripple with less interference to make
sure the Skypecam power supply.
Suggest using the UPS to protect the power supply under allowable conditions
3.2 Turn off
Check and confirm the recording is stopped before turn off the Skypecam, turn off the power
supply switch to “OFF”, or pull the rear panel power switch that can switch power.
Auto resume after power failure
If the Skypecam is shut down abnormally, it can automatically backup video and resume
previous working status after power failure.
Insert the U disk or Micro SD card
Please make sure the Skypecam is not in recording state before inserting the U disk or Micro
SD card, otherwise information will loss or storage equipment will be damaged.
Replace the battery
Please save the setting information and turn off the power supply switch before replacing the
battery. The Skypecam uses button battery. Please check the system time regularly, if the time is not
correct, you need replace the battery. Suggest replacing the battery every year and using the same
type battery.
Note: The setting information must be saved before replacing the battery otherwise information will
lose.
3.3 Standby state
Turn on the Skypecam and enter standby state, the system standby is shown as below:
8
