5
4. Front Wheel Installation
4.1
Use 15mm wrench to loosen the nuts
on the front wheel enough to slide the axle
(A)
into the fork dropouts
(B)
. Make sure to
seat the axle completely in the dropouts.
Insert bent tab of axle washer
(C)
into
small hole at the top of the dropouts.
Make sure washer is on the outside of the
dropouts.
4.2
Tighten the axle nuts
(D)
.
Torque
Requirement: 30-45Nm.
5. Stem/Handlebar Adjustment
5.1
Using a 6mm hex wrench, loosen the
bolt in the front of the stem
(A)
and adjust
the handlebars so that they are level then
re-tighten.
Torque Requirement: 10-12Nm.
5.2
Check to make sure the stem is in line
with the front wheel
(C)
and that the
minimum insertion line
(B)
is not visible.
Use the 6mm hex wrench to loosen the
stem, adjust and then tighten.
Torque
Requirement: 20-23Nm.
5.1
0°
C
5.2
A
B
5.2
C
D
A
B
4.1
4.2
