Copyright © 1991-1997 by Linn Products Limited. All Rights Reserved.
Page 31
Revised Dec 97
Index
PROCEDURE (continued):
8. Feed the rod and insert through the hole on the internal brace and locate the
insert in the mounting hole.
8. Thread a 5 mm Allen bolt (Tonearm collar screw)
with a washer into the insert a couple of turns,
then start to tighten, while unscrewing the rod
from the insert. Continue until the rod is fully
unscrewed from the insert, then remove the rod
from the speaker.
9. Tighten the bolt until the insert is tight and fully
home.
10. Fit the stand base using all 4 bolts to ensure that
there are no other faults.
11. Replace the speaker wadding as you found it. Refit the speaker unit and trim
ring.
If Trim ring was fitted with silicone, use new silicone to secure in place -
Avoid getting silicone on to the unit surround.
12. Audition.
HOLE
BRACE
KEILIDH: REPLACING STAND INSERT
ROD
INSERT
WASHER
BOLT
KEY
CABINET
Summary of Contents for KELTIK
Page 1: ...LOUDSPEAKERS LINN...
