Linn KEILIDH, Owner'S Manual, Page: 11 / 19

9
COMPOSITE BASE
To install the composite base, again lay the speakers on their back or top on a
soft surface. Remove the spikes (if fitted), locknuts and washers from the integral
base. Then remove the four socket-headed screws holding the integral base to
the loudspeaker, and remove the base itself. Screw the composite base to the
loudspeakers, and screw the floor spikes and locknuts into the sockets on the four
corners. Note that the spikes can be adjusted from above using a flat blade screw
driver. Leave the locknuts finger tight for the moment.
NSTALLATION GUIDE Lift the cabinets from the carton by their sides
to avoid damaging the drive units. If you can, keep the packing for
possible future transportation.
INTEGRAL BASE
If you are using the KEILIDHS with the standard base, you will need to install
the spikes. Lay the loudspeakers on their backs on a soft surface. Screw the
floor spikes through the washers into the stand base. Screw the locknuts onto
the spikes, and leave everything finger tight for the moment.
I