16
PROGRAMMING THE KARIK
The KARIK can be programmed from the remote control to play a selection of
tracks.
TO PLAY A SELECTION OF TRACKS
make sure the disc is loaded but not
playing. You can tell that this is the case if the
2
indicator is not lit and
the display is showing the number of tracks on the disc. (If you have just put
the disc in, allow the KARIK the few seconds necessary to read and display
the number of tracks). Press and hold the button marked DISPLAY for about
2 seconds until the display shows
P - - A
which indicates that programming mode A has been entered. (If the display
shows “P--b” you’ve held DISPLAY too long. Press OPEN twice, and start
again). Release DISPLAY and the display will show
P 00
which indicates that the KARIK is ready for you to enter your selection.
Use SKIP
i
or
u
SKIP to enter a track number, or press the appropriate
digits on the remote control. Press DISPLAY again to enter this track as your
selection. The display will show
P 01
indicating that your first selection has been accepted. Enter further track
numbers the same way, pressing DISPLAY to store each track in sequence.
You can enter up to 20 tracks.
The display will show P 02, P 03 ... and so on as each track is programmed in.
TO FINISH THE PROGRAM
Press STOP
o
. The display will show the total
number of tracks you have entered.
TO CHECK OR ADD TO THE PROGRAM
after you have pressed STOP
o
,
press SKIP
i
and the first track in the program will be shown. Pressing
SKIP
i
again will display the second track, and so on. The display shows the
track number, followed by its position in the program. So, “703” signifies that
track 7 is 3rd in the program. If you want to add more tracks, press and hold
.
