![background image](http://html.mh-extra.com/html/linksys/etherfast-befw11p1/etherfast-befw11p1_user-manual_1924617014.webp)
22
Etherfast
®
Wireless AP + Cable/DSL Router with PrintServer
You can access this screen at any time by clicking the Status button.
The Status screen will display current data on your Wireless Access Point
Router. This screen will change if you do not enable PPPoE.
Hardware
• Firmware Version. Displays the current program code installed on the hard-
ware.
• Hardware ID. This is utilized by Linksys to identify this device.
• NAT (Network Address Translation). This will display your current NAT
selection.
Status
Instant Broadband
TM
Series
Wireless Stations
• Access Permission.
When Allow everyone access, the default selection, is utilized, no check is
performed on the station’s address before allowing it to use the Wireless AP
+ Cable/DSL Router.
If you chose Only allow access if on this list, then a station must have an
address that appears on the address list.
• Existing Stations. This lists the IP Addresses of those wireless stations in
your Network with access to the Wireless AP + Cable/DSL Router.
• New Station. To add a new station to the list above, enter its address here and
click the Add button.
When you are ready to save any changes you have made, click the Save but-
ton. To undo any changes, click the Cancel button.
If you have any questions about anything on this page, click the Help button to
bring up the Help window for this screen.
21