Manually Assigning a Static IP Address
Members using static IP on their home network may wish to configure the adap-
tor with static IP. If you have obtained a static IP from your internet service
provider (ISP) and wish to configure your adaptor with your static IP settings,
please follow the instructions below:
1. You will first have to obtain the following information:
• IP Address • Default Gateway • Subnet Mask.
If you are using a router, please contact your router manufacturer for
instructions for retrieving this information from the router directly. If you
are not using a router, please obtain the above information from your ISP.
2. Pick up the telephone receiver of the phone connected to the adaptor,
and dial * * * *. You will hear a voice prompt saying “Linksys configuration
menu”.
3. Press the keys 1 0 1 # on your analog phone to access the Static IP
configuration menu.
4. Press 0 # to disable DHCP, then press 1 to save the setting.
5. Press 1 1 1 # to access the IP Address Menu.
6. Enter your IP Address followed by # (i.e. 1 2 3 * 4 5 * 6 7 * 8 9 # to
represent the IP 123.45.67.89). Press 1 to save the setting.
7. Press 1 3 1 # to access the Default Gateway Menu.
8. Enter your Default Gateway (i.e. 1 2 3 * 4 5 * 6 7 * 8 9 # to represent the
Gateway 123.45.67.89). Press 1 to save the setting.
9. Press 1 2 1 # to access the Subnet Mask Menu.
10. Enter your Subnet Mask (i.e. 2 5 5 * 2 5 5 * 2 5 5 * 0 # to represent
Subnet Mask 255.255.255.0). Press 1 to save the setting.
You have now completed the static IP configuration.
To verify the configuration was correct, please pick up the telephone receiver
on the phone connected to the ATA, and dial * * * * to enter the Linksys
configuration menu. Dial 1 1 0 # to hear the adaptor read back the IP ad-
dress that you have configured. If the IP read out is not the same as what
you have entered in, please repeat steps 1 through 10 once again to ensure
the settings.
