1
USB PORTABLE HARD-DISC
USER MANNUAL
System Requirements
IBM compatibles with USB interface, WINDOWS98/ME/2000
MACINTOSH system with MACOS8.6 or higher
Description of the Indicators on USB Hard Disc Box
A. twin-color: green---ready; red---in use
B. single-color(only when hard-disc is connected): steady---ready; flash---in use
Installation
1.
Confirm that the 2.5’ hard
-disk is set as master mode
2. Open the box and take out the Pcb
3. Install the hard-disc onto the Pcb
4. Put the Pcb with hard-disc back into the box,tighten the screws
Installation of WINDOWS98SE Operating System
1.
Run ‘setup.exe’
in folder named
“
GL811-Win98
”
2. Connect the USB portable hard-disc to the pc. Windows will show that new
hardware has been found and installed;
3. USB hard-disc should pop out in a minute (the new hard-disc should be
divided into sections with FDISK first. Restart the pc if it fails. The icon will
appear and normal operation can start after formatting.)
Installation of WINDOWS2000/ME Operating System
No driver program is necessary. Connect the USB hard-
disc to pc. Click ‘My
computer’ and USB hard
-disc will appear. An icon for online plug should appear
on the lower right corner of the status bar (new hard-disc should be divided into
sections with FDISK first, then its icon will appear and normal operation can start
after formatting).
MAC OS Operation System
The driving software for MAS OS8.6 is ‘GeneUSBCF.SIT’ under the directory
‘MAC’.
1. Copy this file to the desk top and double click it will produce the driver file
automatically;
2. Copy the driver file produced under the extension directory [System
Folder]->[extensions];
3. Connect the USB hard-disc; restart the computer and the USB hard disk will
appear after a while on the desk top (note that the new hard disk should be
divided into sections with FDISK and formatted. The icon will appear and
normal operation possible then.)
4. To MAC_OS_9.0 and later versions, no installation of driving software will
be necessary for using of USB hard disk. Just connect the USB hard disk to
the computer and it will appear on the desk top in a while (Divide the hard
disk into sections with FDISK first. The icon will appear after formatting
and normal operation possible.)
