LL-AF2-ST-SM-ATK42 SuperTag Plus
3
Powering on the device and installation
The device has the multi-function button located on the back side of the
device and a LED light indication located on the front of the device.
Please note the location of the Power Button and LED Lights
Shipping Mode
After initial programming, the device will enter a low power shipping mode.
In this mode the device will perform no operation other than monitor the
pushbutton. To exit shipping mode the user must press and hold the
pushbutton for at least 5 seconds. After a successful exit from shipping
mode the device will only re-enter shipping mode if re-programmed or user
pushbutton sequence to re-enter is performed.
LED behavior
The device has a visible multi-colored LED used to provide user feedback
about device mode and status.
Shipping mode:
Button hold
Red LED blink Red LED solid White LED blink
End state
Button < 1 sec
--
3 sec
--
Shipping mode
Button >= 1 sec
and Button < 3
sec
1x per sec
3 sec
--
Shipping mode
Button > 3 sec
1x per sec
--
5x rapid
Normal
operation
