LinkAYL LK-CP62 Series, Quick Start Manual

Page: 3 / 5

Control Mode

Controler has inching mode and continued ‐ run mode which is default

In the continued ‐ run mode, press the up / down key less than 1.5 seconds, the
motor will run continuously, press the up / down key more than 1.5 seconds, the
motor will stop after running a very short moment

In the inching mode, press the up / down key less than 1.5 seconds, the motor will
stop after running a very short moment, press the up / down key more than 1.5
seconds, the motor will run continuously

Only the manual buttons on the panel, manual switch, remote control and cascade
signal have inching mode

Keep pressing both of UP and STOP button on the controler for 5 seconds, LEDs
flash 3 times and turn off it’s inching mode for the controler, repeat the operation
the controler turns to continued ‐ run mode
Manual control

After power on all the LEDs light for 1 second and turn off, the power indicator LED
normally on

Press reset button, all the LEDs light for 1 second and turn off, reset successfully

L2 will be explosion ‐ flashing after controler receives fire signal

External manual switch is equivalent to controler panel switch

The maximum running time of the motor is 5 minutes

The motor up / down switching time is 500ms
Group Control

By default, L1 is normally on, the rest LEDs are off as group control status

Press UP button, the windows open, LED turns on, turns off after 5 seconds

Press DOWN button, the windows close, LED turns on, turns off after 5 seconds

Press STOP button, ,the motors stop, LED turns on, LED turns off after 1 second
Single Channel Control

Press channel selection keys the corresponding LED lights, channel selected

Press the channel selection button again or no operation on controler thin 10
seconds, LED turns off, channel unselected

In the process of opening/closing the current window, you can select another
channel(s) to drive the window
Remote control

The controler encodes by 433MHz learning code, can store 10 sets of transmission
codes

The controler defaults to multiple channel, single channel controler has the same
way as multiple channel one
Matching Code

Power the controler on, choose the channel(s) you want to set, can be set to any
combination of channel 1 ‐ 5

Pressing STOP button on controler for 5 seconds, LED flashes 3 times and turns off

Choose the channel you want to set on the remote, press [UP] within 15 seconds

LED flashes 3 times and turns off, code matched successfully
Clearing Single Code

Power the controler on

Keep pressing STOP key on the controler for 5S, LED flashes 3 times and turns off

Press DOWN button on the remote within 15 seconds

LED flashes 3 times and turns off, code cleared successfully
Clearing All Codes

Power controler on, pressing STOP & DOWN button on the controler for 5 seconds

LEDs flash 3 times and turn off, all the codes will be deleted after this operation