THMS600 Parts
Lid Window Assembly
To replace the windows in the Stage Lid (1)
use the Window Tool (2) and align the two
wide spacing pins to the Tube Clip Holder
holes and unscrew the Lid Insert (3).
The Stage Lid and Lid Insert should be turned
upside down as shown in the diagram
opposite and reassembled in the order
indicated.
The Lid Insert should be screwed down until
the cover slips are held firmly, then turn the
assembly over and screw down the Lid Insert
until it is felt to come to a stop.
Bottom Window Assembly
Use two narrow spacing pins of Window Tool
(2) to align it to the two holes of Window
Locking Ring (4) and unscrew.
Reassemble the bottom window as shown in
the opposite diagram
Photos/graphics courtesy of linkam.co.uk
Stage Assembly
1. Lemo connector for stage lead
2. Heating element carrier assembly
3. Stage body
4. Stage body water connector
5. Gas purge valve
6. Y-Sample manipulator
7. Stage door
8. Door locking thumbscrew
9. X-Sample manipulator
10. Liquid nitrogen cooling connector
11. Bypass stage body water cooling connector
12. Sample chamber
13. Earth safety contact for lid
15. Heating element wire
16. Stainless steel cooling tube
17. 22mm diameter pure silver
heating block
18. Platinum temperature sensor
19. Sample holder ramp
20. Aperture hole
21. Vertical Sample Holder
1
5
1
6
1
7
1
8
1
9
2
0
2
1
