40
iGrowSeries 100 Installation Manual
960-0001-20
can again be opened. By pressing
Button #8
user can to go
to this option. Wheel can be used to increase or decrease the
values
Shock Protection
: Selecting a shock protection mode helps
in opening the curtain slowly, preventing it to open all at once
and thus preventing sudden temperature changes.
Press
Button #2
to go to night mode setup option. Then,
press Button #6 to go to this option
Note: Covered % is the amount by which the curtain should be
covered.
By pressing
Button #7
user can to go to % covered option.
Wheel can be used to increase or decrease the value
The day mode and the night mode start time can be set to an
absolute value using the screen as shown or to the sunrise
and sunset values.
Location setup can be used to input the coordinates
Press
Button #5
and
OK
to confirm. Then user can change
the time by pressing Buttons
#1, #2, #3, #5, and #6.
Note: The sunrise and sunset values will correctly calculated
only if the location coordinates are entered correctly.
Any one of the available 8 channels can be selected to be an
alarm output. However, typically one would select channels 7
or 8.
Now that you have selected a channel where you can connect
an audible or visual alarm indicator device or a device such as
a “Sensaphone”, you can link this output to an alarm setting
programmed at option 4 of the System Setup Menu. See
Page XXXX below.
The next screen lets you check which alarm conditions will
trigger the relay output.
Alarm Condition Setup
On this screen you can check which alarm conditions you
want to trigger the relay output.
Use button #3 to select. Pressing it a second time will remove
the checkmark.
