9
D4:Mobile Signal
: HDMI input signal, the input resolution up to 1920X1080 @ 60HZ,
backward compatible; compatible Mobile Signal mobile phone signal through the
Micro USB to HDMI input;
D5: DP
: DP signal input,the maximum input resolution / refresh rate to 1920X1080 @
60HZ, backward compatible;
RS232/IR
: Using RJ45 to RS232 line, control through computer control software or in
the control; IR signals can also be transferred via cable, the remote control receiver
away from the device may also be implemented by infrared remote control;
Audio
: Bind VGA video signal input, can be synchronized switching with the VGA
signal;
2.Output section:
The input section of the chassis's rear panel
OUTPUT
frame,
HDMI
interface directly
connected to the display unit; Audio can be directly connected to an external sound,
high power audio playback.
Chapter Five Remote control operation
Properly connect the output signal and display terminal , then you need to properly
connect theinput signal source and the device . via remote control, chassis button
and control software to set different display modes, such as quad display, select a
signal full-screen display, the PIP and other functions . This chapter describes how to
operate the equipment via infrared remote control, if you are use our devices for the
first time, configure or settings as follows
1.The window position of signal definition:
Beforeusing Quad video multi viewer, we must understand the definition of signal
1, signal 2, signal 3 and signal 4:
Signal 1 is also called window1,in the top left corner of the screen;
Signal 2 is also known as window 2, in the lower left corner of the screen;
Signal 3 also known as window 3, in the upper right corner of the screen;
Signal 4also known as window 4, in the lower right corner of the screen;
As the picture show:
