Link-Belt PULSE, Calibration Manual, Page: 27 / 69

25. Wait at least 30 seconds for the accurate load
weight. (If an adjustment is made to the friction
modifier sliders, slightly engage the boom hoist hy-
draulics again and wait at least 30 seconds for the
accurate load weight.) Use the number on the left
for lower piston pressures and the number on the
right for higher piston pressures. Adjust sliders un-
til the correct weight is displayed.
Note: Static load adjustment will not show cor-
rection until Step 26 is completed.
26. Press Button 3 to select the chosen setting.
27. The load reading must be equal to actual load to
+10% over actual load.
It must not be below ac-
tual load.
28. Boom up to 80 degrees. Use Buttons 2 and/or 4 to
move the highlighted position to the 80 degree ad-
justment slider.
29. Wait at least 30 seconds for the accurate load weight.
(If an adjustment is made to the friction modifier
sliders, slightly engage the boom hoist hydraulics
again and wait at least 30 seconds for the accurate
load weight.) Use the number on the left for lower
piston pressures and the number on the right for
higher piston pressures. Adjust sliders until the cor-
rect weight is displayed.
Note: Static load adjustment will not show cor-
rection until Step 30 is completed.
30. Press Button 3 to select the chosen setting.
31. The load reading must be equal to actual load to
+10% over actual load.
It must not be below ac-
tual load.
32. Repeat the complete procedures above for Medi-
um Boom (half extended boom length) and Long
Boom (fully extended boom length) lengths.
33. Medium Boom (half extended boom length) screens.