Linhai M565L EURO IV, Owner'S Manual

Page: 92 / 101

M565Li OWNER’S/OPERATOR’S MANUAL
16. MAINTENCE
92
Preparation after Storage
Taking the ATV out of storage and correctly preparing it will assure many miles
and hours of trouble-free riding. Linhai recommends following procedure to
prepare your ATV.
1. Clean the ATV thoroughly.
2. Clean the engine. Remove the cloth from the exhaust system.
3. Check all control wires and cables for signs of wear or fraying. Replace if
necessary.
4. Change the engine/transmission oil and filter if necessary.
5. Check the coolant level and add properly mixed coolant as necessary.
6. Charge the battery; then install. Connect the battery cables making sure to
connect the positive cable first.
Before installing the battery, make sure the ignition switch is in the OFF
position.
7. Check the entire brake systems (fluid level, pads, etc.), all controls, headlights,
taillight, brakelight, and headlight aim; adjust or replace if necessary.
8. Check the tire pressure. Inflate to recommended pressure as necessary.
9. Tighten all nuts, bolts, making sure all important nutsand bolts are tightened to
specifications.
10. Make sure the steering moves freely and does not stick.
11. Check the spark plug. Clean or replace as necessary.
Transporting the ATV
Whenever the ATV is to be transported, the following measures should be taken:
1. Turn off the engine and remove the key.
2. Be sure the fuel cap, oil cap, and seat are installed correctly.
3. Always tie the frame of the ATV to the transporting until securely using
suitable straps or rope.
4. Always place the transmission in gear and lock the parking brake.