Linhai HY740STL 2018, Service Manual

Page: 175 / 217

CHAPTER 6 BRAKES
M750L SERVICE MANUAL 18.0
CHAPTER 6 BRAKES PAGE. 6- 7
Master Cylinder Mounting
Bolt Torque 55 in. lbs . (6 N m)
Brake Line Banjo Bolt Torque
15 ft. lbs. (21 Nm )
3. Fill reservoir with DOT 3 fluid.
4. Follow bleeding procedure, Check all
connections for leaks and repair if necessary.
6.7 FRONT PAD REMOVAL / INSPECTION / INSTALLATION
NOTE: The brake pads should be replaced as a set.
REMOVAL
1. Elevate and support front of ATV safely.
CAUT ION: Use care w hen supporting vehicle
so that it does not tip or fall. Severe injury m ay
occur if machine tips or falls.
2. Remove the front wheel.
3. Remove caliper from mounting bracket.
4. Push caliper piston into caliper bore slowly
using a C-clamp or locking pliers with pads
installed.
NOTE: Brake fluid will be forced through
compensating port into master cylinder fluid
reservoir when piston is pushed back into
caliper. Remove excess fluid from reservoir as
required.
5. Push mounting bracket inward and slip
outer brake pad past edge. Remove inner pad.
6. Measure the thickness of the pad material.
Replace pads if worn beyond the service limit.
INSPECTION
Measure the thickness of the pad friction
material. Replace pads if worn beyond the
service limit.
Service Limit 0.3/64"(1 mm)