Linertec LTS-200 Series, Instruction Manual

Page: 32 / 76

29
• The [F3] [0 SET] cannot reset the vertical angle to 0.
• Pressing the [F3] [0 SET] accidentally during measurement does not reset the horizontal
angle to 0 unless you press it again. Once the buzzer stops sounding, you can go to the next
step.
• You can reset the horizontal angle to 0 any time except when it has been held.
5.3 Holding the horizontal angle
To hold the horizontal angle currently being
displayed, press [F3] [HOLD] twice in succession.
The horizontal angle value is displayed in reverse
video when being held.
• Pressing [F5] [MODE] and press [F3] [HOLD].
• The [F3] [HOLD] cannot hold the vertical angle or distance.
• To release the horizontal angle from being held, press [F3] [HOLD] once.
• Pressing [F3] [HOLD] accidentally during measurement does not hold the horizontal angle
unless you press it again. Once the buzzer stops sounding you can go to the next step.
5.4 Inputting an arbitrary horizontal angle
In case of Horizontal angle 123° 45' 20" input.
Press [F5] [MODE] .
Press [F2] [ANG SET] to display the ANGLE SET screen, then press [F4] [ ] to
move the cursor to “2. H.ANGLE INPUT”.