4-5
4 . Waiting for button
5. Waiting for button release
6. Motor lost
7. Overcurrent
8. Overheating*
9. Low voltage
10. High voltage
11. Motors far apart - reset required
12. Destination above upper limit
13. Destination below lower limit
14. Internal error
15. Collision detection
Thermometer will be flashing, wait 10 mins. to allow the motor to cool.
Calibration (CAL)
Adjust the default height to the actual measured height by using the up and down arrow buttons.
Setting Memory Buttons
To set the memory buttons use the up and down arrow to navigate to the desired height. Rapidly
press and release the up and down arrow buttons simultaneously three times.
The letter "S" will display on the screen.
Press and release the memory button you've chosen for the current height and the display will change
to "S1", "S2", "S3", or "S4".
To reach the memory setting after it has been programmed, press and hold that memory button until
the table stops moving.
rES- Reset
rES
for Reset. will force the system into Reset mode.
