Linear aigis D3P Series, Installation And Operating Instructions Manual, Page: 6 / 12

6
11. Plug the test monitor into the BNC Test Monitor Jack shown in Figure 5. Adjust the Zoom and Focus
settings as desired.
Figure 5 - Adjust bracket, focus and zoom
12. Reinstall the dome cover onto the housing base by aligning the notch in the dome cover with the
alignment tab as shown in Figure 5, then pressing down until the cover snaps into place. Ensure that
the cover is properly seated.
13. Twist the bubble relative to the dome cover until the cutout in the covert liner is pointed in the
same direction as the camera.
14. Remove the protective film from the dome bubble to complete the installation.
Rotate Image 360
˚
Pan
360
˚
Tilt 90
˚
Zoom and Focus Knobs
Dome Cover
Alignment Tab
Local BNC Test Monitor
Connection (not included
for part numbers ending
in “E”)