5
dc2026afa
DEMO MANUAL DC2026A
Quick start GuiDe
4) Click on the Serial Monitor, which looks like a magnifying glass:
This will bring up the monitor window:
Select Newline terminator and set the baud rate to 115200. You should see a “hello” message – this indicates that
serial communication is set up properly, and that the DC590 emulator firmware is properly installed. Pressing the
RESET button on the Linduino One will cause the message to be sent again. If this message does not appear, try a
different COM port.
(
Note
: The DC590 emulator sketch can be restored by following the procedure detailed below for uploading the
DC934 sketch, substituting the DC590 sketch which is located in File
→
Sketchbook
→
Utilities
→
DC590B.)
5) Quit the Arduino IDE. Note that a restart is required every time the Sketchbook location is changed.
