Linear Power 992IQ Owner'S Manual And Installation Manual Download Page 4

Page: 4 / 4

Specifications

992IQ

Power output @ 4 ohms RMS @ 12.5 volts

50X2

THD @ full output 20-20KHz

.08%

Slew Rate volts/microsecond

8Vms

Damping factor @ 4 ohms

>100

Channel separation

70dB

Maximum current

4 ohms

12A

2 ohms

16A

Idle

.7A

Fuse rating (12 Volt Power Feed)

20A

Dimensions

2x7.7x7.5

Summary of Contents for 992IQ

Page 1: ...will deliver a significant increase in power into 2 ohm stereo loads Amplifier reliability is accomplished by the amplifier operation level being set at approximately 50 of output transistors rated p...

Page 2: ...hm speaker impedance To use these amplifiers in that configuration the internal taps must be changed Removing the faceplate and changing the spade connectors from the 4 setting to the 2 setting accomp...

Page 3: ...noise shield To maintain this protection be sure the metal case of the amp does not touch the metal of the car Do not remove or damage the rubber grommets which provide electrical insulation and vibra...

Page 4: ...4 ohms RMS 12 5 volts 50X2 THD full output 20 20KHz 08 Slew Rate volts microsecond 8Vms Damping factor 4 ohms 100 Channel separation 70dB Maximum current 4 ohms 12A 2 ohms 16A Idle 7A Fuse rating 12 V...