27
DO235SW
www.domo-elektro.be
EN
USE
FILL THE WATER RESERVOIR BEFORE USE
1.
Remove the water reservoir and turn it upside down.
2.
Open the screw cap and fill the reservoir with water through the opening. Do not
exceed the maximum level of the water reservoir.
Note: a detergent can be added to the water if desired. A cleaning product with a
PH neutral value between 7 and 8 is recommended.
3.
Place the screw cap back on the reservoir after filling.
4.
Place the reservoir back on the appliance upside down.
USE
1.
Press the on/off button to turn the appliance on. When you turn the appliance on, the rollers in
the cleaning head will start rotating. The indicator light will illuminate to show the appliance is in
operation.
2.
Press the water spray button to pump water into the cleaning head. The indicator light flashes green
to show the water spray button is on. The 1st roller will get wet so you can then clean the floor. The
2nd roller remains dry so you can dry the floor at the same time.
3.
Press the water spray button again to stop water spraying.
4.
Press the on/off button again to turn off the appliance.
·
The appliance is equipped with a safety device that will ensure the appliance switches itself off, for
example, if large objects or fingers get into the cleaning head. This is for personal safety and to protect
the motor. To rewind the rollers, press the power button again.
· Do not use the appliance on carpet.
· After use, place the appliance in its storage base.
CLEANING AND MAINTENANCE
CLEANING THE MACHINE
Clean the machine with a slightly moist soft cloth. Dry the machine off well. Never submerge the machine
in water!
The storage base can be cleaned using warm water and a mild detergent. Dry thoroughly afterwards.
CLEANING THE CLEANING HEAD (ROLLERS)
1.
Remove the cover on the right side of the cleaning head. Note the arrows for this.
2.
Gently pull out the rollers from the cleaning head. Clean the cleaning head with a damp cloth and
then dry.
3.
Clean the accessories in warm water with a mild detergent. Let them dry well.
4.
Slide the rollers back into the cleaning head. Then put the cover back in place. You will hear a click
when it is correctly positioned.
