31
DO1000S
www.domo-elektro.be
EN
USE
This steam generator offers 2 options: dry ironing or steam ironing. Follow the instructions
below. Also carefully read the ironing tips at the end of this section before using the appliance.
DRY IRONING
1.
Place the iron on the thermal insulation pads of the steam generator.
2.
Put the plug into the outlet and press the on/off button.
3.
Select the desired temperature with the temperature dial, according to the kind of fabric
that needs to be ironed. The temperature indicator will light up and the iron will start
heating up.
4. When the temperature indicator goes out, the selected temperature has been reached.
You can now start ironing.
Caution: Never touch the hot soleplate!
STEAM IRONING
Caution: do not plug in the appliance yet at this point.
1.
Grab the water tank of the steam generator by the handle and press the trigger on the
the handle to pull the water tank out of the generator. Open the filling cap and fill the
water tank with water. Make sure that you do not exceed the maximum level (1.7 L). Use
only mains water or 50 % mains water and 50 % de-mineralised water if you have hard
water.
2. Place the water tank back into the steam generator. Caution: if the reservoir is not
replaced properly, the machine will not produce any steam.
3.
Put the plug into the outlet and press the on/off button. Set the temperature dial to the
desired temperature, according to the kind of fabric, and the temperature indicator will
light up.
4. The water in the water reservoir will heat up and after
a few minutes the temperature light will go out. This
means that the steam generator has reached the correct
temperature.
5.
Selection of the amount of steam is done with the
steam selection button. The steam indication light of the
amount selected will light up blue. If the appliance is still
heating up, the light will flash.
6. To iron with steam, press the steam button on the inside of the iron’s handle. A
continuous flow of steam will come out of the sole. When you release the button, you will
iron dry, without steam.
7.
Use a steam boost to get rid of stubborn wrinkles. Press the steam button twice in rapid
succession. There is a 15-second wait in order to use the steam boost
a 2nd time. Please note: the steam amount must be set to medium or
high. Select this amount with the steam selection button.
