User Manual
4
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (April 2007)
For Home and Office Use
Tested to Comply with
FCC Standards
DIP Switch 5: Power ON USB mode
When DIP switch 5 is ON, the internal power supply will automatically switch to Stand By
and the HDDs will power down when the host computer is switched OFF, goes into Stand
By or when no USB cable is connected.
When DIP switch 5 is OFF the power switch defines the status of the Quad Drive enclosure.
Connection, driver installation and HDD formatting
The system always requires a short time to boot up and configure HDDs after it powers on!
Windows 2000 / XP / Vista
When used with a Windows PC there is no need for an additional driver, simply connect the
Quad Drive HDD enclosure and
Windows will automatically recognise and install the
enclosure. After the initial installation formatting of the hard disks is required, if you are using
the Combined HDD Mode. In this case please follow the formatting procedures according to
your operation system and refer to its HELP system if required.
Mac OS Initialization Procedure
Execute the disk utility and initialize all HDDs by “Mac
OS expansion” as individual disks.
When you want to use a HDD with both Mac OS and
Windows, with a capacity of 137GB or less, please
format the HDD with FAT32 via Windows.
Combined Mode Initialisation using HFS
Mac OS will only display (detect) Master HDDs, it will not display (detect) Slave HDDs at
first. Every HDD must initially be connected and partitioned as a Master. Once this has been
done the HDDs can be set to Master and Slave and the enclosure can be set to combined
mode. If the capacity of the Master still does not show the combined capacity then ensure
that you choose only “one partition” per HDD and re-initialise the HDDs.
Technical Data
Dimensions: 135 x 172 x 248 mm
Weight: approx. 2.4kg (Weight of hard disks not included)
Interface: USB 2.0
Power supply specifications: Input: 100V - 240V AC, 50/60Hz; Output: +5V 4.0A / +12V 6.0A (maximum)
Operating Conditions: Temperature 5-35°C, Humidity 20-80% (non condensing)
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
Consult the dealer or an experienced technician for help
file system
OS
NTFS FAT32 HFS
Windows ME
×
×
Win 2000/XP
×
Windows Vista
×
×
Mac OS
×
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (April 2007)
For Home and Office Use
Tested to Comply with
FCC Standards
Quad Drive
Enclosure USB 2.0
User Manual
English
LINDY No. 42822, 42823
www.LINDY.com
