English Manual
English 3
2.
Place one or two hard drive(s) in the slot. Make sure the SATA connector is lined up
with the connector inside the Mobile Rack.
3.
Carefully push the hard drive into the Mobile Rack, so that the drive’s SATA
connector is seated securely, then close the door and lock it. It must be in the lock
position when in use. This prevents unexpected removal while working.
4.
Adjust the DIP switch to set the storage policy:
5.
Plug the included switching power adapter into the enclosure´s power adapter jack,
then plug the switching power adapter into a reliable power source.
6.
Use the included USB 3.0 cable to plug the USB 3.0 Dual 2,5“ SATA Mobile RAID
into a USB 3.0 port of your computer and switch it on. Make sure the Power LED is lit.
Caution:
Changing the RAID mode destroys data stored on the Mobile Rack,
If you have saved data on the drives, back up data before following these steps.
Note:
1. Users are advised to disable the device from the computer before unplugging the
cable or turning off the device.
2. If the hard drive does not support ACCESS signal, then the
HDD ACTIVE LED
will not flash when the hard drive is in use.
3. If the system cannot detect the device, please go to device management and
enable it.
4. Do not open the door or turn off the power of the
Mobile Rack
while the hard drive
is busy, this may cause damage to you hard drive.
5. It must be in the lock position when in use. This prevents unexpected removal
while working.
6. Do not force the door to open while it is locked, otherwise, you will damage the
lock.
Driver Installation
Windows will automatically detect and install the drivers.
An additional drive icon will appear in MY COMPUTER when the USB 3.0 Dual
2,5“ SATA Mobile RAID is connected.
1: ON
2: ON
1: ON
2: OFF
1: OFF
2: ON
1: OFF
2: OFF