Fortsetzung: BETRIEB (DEUTSCH)
Partitionierung der Festplatte
Wenn Sie eine brandneue Festplatte anschließen ist
diese höchstwahrscheinlich nicht partitioniert und Ihr
Betriebssystem wird kein Laufwerk anzeigen!
Verwenden Sie das
Partitionierungsprogramm Ihres
Betriebssystems wie zum Beispiel FDISK. Weitergehende
Informationen hierzu finden Sie im Hilfesystem Ihres
Betriebssystem oder wenden Sie sich an einen erfahrenen
PC-Techniker.
UTILISATION (FRANCAIS)
PUISSANCE NECESSAIRE
Ce boîtier DOIT uniquement être utilisé avec
l’alimentation fournie.
Il peut être connecté à n’importe quel port USB.
Installation du pilote
Les systèmes d’exploitation actuels comme Windows XP,
2000, ME incluent directement le pilote USB 2.0 et il sera
mis à jour automatiquement. Si le disque dur externe est
reconnu correctement en tant que périphérique USB 2.0
n’essayez pas de réinstaller le pilote.
Veuillez vous référer au manuel fourni pour l’installation
des pilotes sous d’autres systèmes.
Installation du disque dur
Si vous installez un nouveau disque dur et qu’il n’est pas
reconnu par le système, il est nécessaire de le partitionner
avant son utilisation (FDISK ou autre).
UTILIZZO
(ITALIANO)
Alimentazione richiesta.
Questo astuccio DEVE essere alimentato solo
con l’alimentatore fornito a corredo e può essere
connesso a qualsiasi porta USB.
Installazione dei Driver
I sistemi operativi moderni come Windows XP, 2000 e ME
includono già tutto il software necessario (se le porte USB
2,0 sono già correttamente installate). Se il drive viene
correttamente riconosciuto come periferica USB 2.0 non
procedete all’installazione di alcun driver! In caso contrario
richiedete i driver aggiornati per il controller USB a chi vi ha
fornito il computer o scaricateli dal corrispondente sito web.
Partizionamento dell’HDD
Se state utilizzando un Hard Disk esso potrebbe non
essere partizionato. Utilizzate il programma di
partizionamento del vostro sistema operativo (FDISK o
similare). Potrete trovare informazioni su questa
operazione nella guida del vostro sistema operativo o
chiedete aiuto ad un tecnico esperto.
Technical Data
For 3.5” hard drives!
Interface: USB 2.0 to IDE ATA/133
Enclosure dimensions approx.: 210 x 120 x 30mm
Enclosure weight: 0.4kg approx.
Operating temperature: -5…40°C,
Humidity: 10…80%, non condensing
(Operating temperature and humidity are dependent
on the installed hard drive. Please refer to your drives
data sheet!)
For indoor use only
Packing List
USB 2.0 Hard Drive Enclosure
USB A/B connection cable, 1m approx.
Bag with small HDD installation screws, screwdriver
Driver disk for Windows 98
External Power supply with separate power cable
This manual
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B Digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
Consult the dealer or an experienced radio/TV technician for help
You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
For Home and Office Use
Tested to Comply
with FCC Standards
LINDY No. 42906
©
LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - First Edition, NOV 2005